Precautions for installation and adjustment of CNC bending machine

CNC bending machine mold installation and debugging what precautions? CNC bending machine mold is composed of many parts, so be sure to check the state of the equipment when installing, and strictly follow the steps, while paying attention to safety when installing and debugging, CNC bending machine mold installation The debugging process.

1, the adjustment of the machine, before the installation, first of all to adjust the machine performance, this process must be patient and serious, check the machine is not a dust and used iron debris, etc., to carry out the necessary clean-up to reduce Late troubles.

2, the slider stroke adjustment, pay attention to check the thickness of the mold and pay attention to check the ratio of the upper and lower modules is not normal, the module is normally controlled in the trip line switch point, this must pay attention.

3, the adjustment of the travel module, which is to adjust the upper point of the module, in the module to the highest point, the switch is set, and set aside the slider's position, while also in the downlink when the deceleration Modules to better protect the machine and mold.

4. The adjustment of the gap is mainly to measure the distance between the upper module and the lower module first. The specific gap setting is determined according to the folded plate.

5, the adjustment of the angle, the adjustment of this angle has a certain relationship with the product, in general, folded 90 ° mold, then the middle angle must be greater than the two sides of the angle, then its elasticity can be adjusted according to the screws, in the bending In the meantime, the pressure gauge can be used to adjust the pressure and prevent the mold from chipping.