A large truck in Nanning crashed into an electric car and killed one mother and another woman.

A large truck in Nanning hits an electric car to cause a mother and daughter to die and hurt a diesel generator | diesel generator price / 2012-09-07

On the morning of September 6, at the entrance of the grain and oil wholesale market at Wuyi West Road in Nanning, a large truck crashed into an electric car, causing the mother and daughter of the electric car to die.
At 12:00 noon on the same day, a large truck with a foreign license was parked at the entrance of the 51 grain and oil wholesale market. The front of the wagon was pressing against an electric vehicle. A woman was lying next to the electric vehicle. After being diagnosed by an emergency doctor, the woman had no signs of life. Several traffic police segregated the site and then began investigations and evidence collection.
“At that time, the truck wanted to turn into the grain and oil market from Wuyi Road and ran into the mother and daughter who were driving in the slow lane.” One witness on the roadside said that the time of the incident was about 11am. From the Qingchuan Bridge to the east of Wuyi Road, the trucks are turning into the grain and oil market at a faster rate. Perhaps the driver’s eyes are blocked and there is no time to brake. As to whether this claim is true, officials have not responded. Traffic police are investigating the cause of the accident.
Another witness said that at the time the mother and daughter, the daughter's injury is lighter, consciousness is still awake, she kept shouting, so that passers-by to save her mother as soon as possible. When she found out that her mother had stopped moving, she was in a coma.
In the emergency department of the Second People's Hospital of Nanning, the injured woman was awake. She was sleeping in the bed, and her feet and hands were severely wounded. The injured woman told reporters that she was carrying her mother in an electric vehicle. She was also driving from the Qingchuan Bridge to Wuyi East Road. When she came to the scene, the truck turned to the right and entered the grain and oil market. She was knocked down and she was knocked down. After that, people will not be saved afterwards.
During the accident scene interview, the reporter observed that large trucks along the May 1st intersection of Shajing are frequent and there are many specialized markets on both sides of the May 1st West Road. Since there is no barrier installed in the middle of the road section, there is no design deceleration zone at the intersection of the market, resulting in a chaotic traffic situation in this area. The owners of some shops in the vicinity have called for and hope that the relevant departments can install traffic warning lights and deceleration belts at the gates of vehicles that flow into more markets.
Next:The old man knocks over the three-year-old grandson of horse honeycomb and causes hepatorenal failure
Prev:Hunan Phoenix denied investing 5.5 billion yuan in copying ancient city called decompression protection

Hard Turning

Hard turning
Hard Turning refers to the process of single point cutting of hardened pieces within the 2 micron range with hardness between 58 and 70 HRC.


Hard Turning Process
In the grinding process, because the work piece is turning slowly, the wheel speed has to be considered in relation to the cutting speed. In the turning process, on the other hand, the work piece takes care of the cutting speed, whilst the tool performs the contouring. In consequence the high speed of the grinding wheel causes the work piece to produce a large quantity of small chips, whilst the turning process forms a continuous chip, which nearly always disintegrates into smaller pieces. Therefore one can see that grinding requires more time and energy per unit volume than turning. Another difference between turning and grinding is that with the latter it is only possible to remove an extremely small quantity of material, for instance with a thickness of only 1 µm. But turning is characterised by a minimal chip thickness of hundredths of a millimetre. That`s why high-precision hard turning requires a different strategy to reach exactly the dimension required.

Hard Turning,Hard Turning Parts,Slender Shaft Pin,Custom Spare Parts

Dayue Precision Technology (Dongguan) Co., Ltd. , https://www.dayuechn.com